Cookie Img
Back to top
   Call Me Free Offline
Home » Products » Ceramic Adhesive » Vitrified Tile Adhesive

Vitrified Tile Adhesive

Vitrified Tile Adhesive
Vitrified Tile Adhesive
Product Code : 03
Product Description

E-T3 Polished Tile Microlite Vitrified Tile Glue

Where to use

  • Suitable for the size less than or equal to 400 x 800 ceramic tile in the indoor and outdoor concrete or cement mortar wall body or vertical paste, high-level exterior wall should be chosen Elokt strong ceramic tile adhesive.
  • Apply to pave any floor tile
Product Features
  • Single-part product , add water gently used, construction is simple
  • Strong cohesive force, low shrinkage rate, reduce caused by shrinkage crack
  • Don't soak wet brick wall during construction, convenient and quick, improve work efficiency
  • Non-toxic, no radiation, environmental protection products.

Construction Technology

Base level requirements

Base level should level off, clean, strong, no dust, grease and dirt, and other loose materials.

Stirring and mixing

The water poured into the container first, and then add the powder in proportion, with  an electric mixer to form a fully agglomerate, uniform paste, let stand for about 5 minutes to make a little stir again can use.

The proportions【water: powder = (4.8 5.2) kg: 20 kg.

Construction technology

In tooth type scraping board will stir good ceramic tile adhesive batch of base surface,  uniform distribution, and into strips dentate, each batch of about 1 ㎡ daub, then rubbing on the pressure in the ceramic tile;

If ceramic tile has a deep groove on the back or deep concave lines, in addition to the base level with ceramic tile adhesive, but should also in ceramic tile with adhesive on the back.

Packaging and Storage

  • 20 kg/bag
  • Should be stored in a cool and dry place, pay attention to moisture
  • Not unsealed product, shelf life 12 months

Tensile adhesive strength

≥ 0.5 MPa

After flooding tensile adhesive strength

≥ 0.5 MPa

Hot tensile adhesive strength after the cold

≥ 0.5 MPa

After freezing and thawing cycle tensile adhesive strength

≥ 0.5 MPa

Open assembly time20min tensile adhesive strength

≥ 0.5 MPa


KESHUN WATERPROOF TECHNOLOGY CO., LTD.

Contact Us

( *represents compulsory fields )

Tips on getting accurate quotes. Please include product name, order quantity, usage, special requests if any in your inquiry.