E-S83 Multi-functional ceramic tile wall renovation putty
Where to use
The old wall surface decoration (such as: coating, ceramic tile, Mosaic, stone, etc.) renovated blow putty leveling.
- The product of JG/T157-2004 building exterior wall with puttyP type standard
- Resistance to aging, ensure finish lasting
- Mutual affinity, particularly strong cohesive force
- The product of only group share, add water gently used, to ensure the construction quality.
- Strong flexibility, minor cracks can override base material
- Good resistance to penetration capability, maintain the surface of wall and the paint is dry
- The surface is smooth, save the surface coating.
- Non-toxic, no radiation, environmental protection products.
Construction surface should be clean, strong and smooth, no empty drum, no pulverization, no dust, no oil stain and other loose materials. Correctly handle base surface to obtain good leveling effect is important.
Stirring and mixing
Add water into the container first, and then add the powder in proportion, with an electric mixer at the same time into uniform no grain of paste, let stand for 5 minutes and make a little stir again can use. Mixing ratio: 【 water: powder = (8-9) kg: 25 kg】
Construction and maintenance
- Stir with scraper will good putty with the base surface, and then erased, general wipe scraping 2-3 times
- The construction of every times the thickness of 0.5 ~ 1 mm (more than the thickness should be stratified batch), two times construction time interval about 4 hours (depends on the weather)
- The last time after completion of construction, with fine sand paper 1 ~ 2 days will leave a mark or uneven of the construction of sand, grinding the metope after dust clean
- The scraping putty layer can be carried out after proper water curing, can accelerate the alkali subsided, 3 ~ 7 days later when the PH value in meeting the requirements of the coating, can besmear brushes a variety of coatings.
Technical Data Sheet
Drying time（Surface drying）/h
Initial dry cracking resistance（6h）
Manual can be polished
Water absorption （g/10min）
Standard state adhesive strength,Mpa
Dynamic cracking resistance/mm
≥ 0.1，< 0.3
- This product is suitable for use in 5 to 40 ℃ environment
- Not in the rain under the condition of construction
- Stir well putty should be finished in 2 to 3 hours, shall be maintained during intermittent stirring
- Avoid by all means will have hard putty water mixing before use.
1.3 kg / ㎡ / mm (surface roughness, can affect the dosage)
Packaging and Storage
This product is 20 kg/bag, should be stored in ventilated, dry place, pay attention to moisture;
Submissions of product, shelf life 12 months.
Product Color: Gray, white